News Center
Location：主页 > 英文版 > Lean consulting > Q & A >
How to maintain the assembly line?
source：Zhong Ke Hua Feiclick：time：2017-09-22 10:31
Before we pay attention to the maintenance of the assembly line, let's first briefly understand the plane layout of the assembly line. Assembly line layout is circular or a font, and machining line layout is usually type U, type S or type, in addition, also according to the line size, length, yield, plant pattern and other specific circumstances.
Assembly line contains all parts maintenance and maintenance methods
1, line head gearbox repair and maintenance: the first use of three months or so after the gear box oil on the net, and then use diesel or gasoline cleaning gear box, put the net after the new oil is added to the middle of the immediate observation window. Thereafter, the lubricant is changed every year. But note that too much lubrication may trigger fever reducer, motor load is too large to cause the motor protection switch off. And too little oil may cause heating of the reduction box, noise increase and reduction box hanging and scrapped.
2, chain maintenance and repair: the chain in the long run, will lead to the original lubricating oil heating, volatile, resulting in the operation of the uneven, noise increases, crawl and other faults. For this problem, you can open the end of the seal plate, to the chain with butter or a little more lubricating oil, etc..
3, head motor repair and maintenance: prohibit motor water, motor with diesel or liquid and other organic compounds, because this will lead to electrical insulation damage and equipment failure.
Also note that line maintenance is not only the maintenance of hardware, but also pay attention to the formal operation of the operator.
The plane design of pipeline shall ensure that parts of the route is the shortest and the production is convenient for workers to operate, auxiliary service facilities, the most effective use of the production area, and consider the line installed between the articulation. To meet these requirements, the assembly line layout should take into account the form of the assembly line, assembly line installation, and other issues.
Lines in the plant layout, general assembly line with line vertical layout. Moreover, the layout interval of the equipment should be satisfied with the conditions of reasonable, appropriate density, convenient operation, favorable logistics, suitable for maintenance and easy management. The assembly line price is more expensive than the ordinary packing equipment, and the daily maintenance and repair is particularly important.
